Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Entering the vehicle while it is running via remote start

Subaru Crosstrek Owners Manual / Starting and operating / Remote engine start system (dealer option) / Entering the vehicle while it is running via remote start

1. Unlock the vehicle doors using the keyless access function (if equipped) or remote keyless entry system. If the vehicle's doors are unlocked manually using the key, the vehicle's alarm system will trigger (if the alarm system is armed prior to activating the remote engine start system) and the engine will turn off.

Perform either of the following procedures to disarm the alarm system. Refer to "Alarm system" F2-26.

2. Enter the vehicle.

3. The engine will shut down when any door or the rear gate is opened.

4. Insert the key into the ignition switch and turn to the "START" position to restart the engine.

Entering the vehicle following remote engine start shutdown

An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown.

Pre-heating or pre-cooling the interior of the vehicle

Before exiting the vehicle, set the temperature controls to the desired setting and operation. After the system starts the engine, the heater or air conditioning will activate and heat or cool the interior to your setting.

Remote start safety features
For safety and security reasons, the remote engine start system will prevent starting (or stop the engine if running) and sound the horn twice if any of the following conditions is detected. In ad ...

Service mode (models without "keyless access with push-button start system")
In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced. To engage or disengage service mode: ...

Other materials:

Power steering warning light
This warning light illuminates when the ignition switch is turned to the "ON" position and turns off after the engine has started. This indicates that the warning system is working properly. While the engine is running, this warning light illuminates when a malfunction has been detected ...

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control PanelINSPECTION1. CHECK ILLUMINATION1. Check the illumination operation when battery voltage is applied between the terminals of control panel.• Manual A/C modelTerminal No.Inspection conditionsSpecificationConnection diagram14 (+) — 12 ( ...

Dtc p0137 o2 sensor circuit low voltage bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0137 O2 SENSOR CIRCUIT LOW VOLTAGE BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...

© 2016-2025 Copyright www.sucross.com