LUBRICATION(H4DO) > Engine Lubrication System Trouble in General
INSPECTION
Before performing diagnostics, make sure that the engine oil level is correct and no oil leakage exists.
Trouble | Possible cause | Corrective action |
Warning light remains ON. | a. Oil pressure switch failure | |
Cracked diaphragm or oil leakage within switch | Replace. | |
Broken spring or seized contacts | Replace. | |
b. Low oil pressure | ||
Clogging of oil filter | Replace. | |
Malfunction of oil by-pass valve in oil filter | Replace. | |
Clogged oil passage | Clean. | |
Excessive tip clearance and side clearance of oil pump rotor | Replace. | |
Clogged oil strainer or broken pipe | Clean or replace. | |
c. No oil pressure | ||
Insufficient engine oil (degradation, etc.) | Replace. | |
Broken pipe of oil strainer | Replace. | |
Stuck oil pump rotor | Replace. | |
Warning light does not illuminate. | a. Malfunction of combination meter | Replace. |
b. Poor contact of switch contact points | Replace. | |
c. Disconnection of wiring | Repair. | |
Warning light flickers momentarily. | a. Defective terminal contact | Repair. |
b. Defective wiring harness | Repair. | |
c. Oil pressure switch failure | ||
Cracked diaphragm or oil leakage within switch | Replace. | |
Broken spring or seized contacts | Replace. | |
d. Low oil pressure | ||
Clogging of oil filter | Replace. | |
Malfunction of oil by-pass valve in oil filter | Replace. | |
Clogged oil passage | Clean. | |
Excessive tip clearance and side clearance of oil pump rotor | Replace. | |
Clogged oil strainer or broken pipe | Clean or replace. |
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearINSPECTION1. Taper roller bearingReplace the bearings in the following cases.• In case of broken or rusty bearings• In case of worn or damaged bearings• When the bearings fail to turn smoothly or emit noise in rotat ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission HarnessINSPECTION1. Visually check the harness and connector for damage or crack.2. Check the harness terminal for rust, disconnection or poor contact.3. Check the continuity between harness terminals.NOTE:For details of transmission harnes ...
Dtc p1451 evap system clog detected (pipe)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1451 EVAP SYSTEM CLOG DETECTED (PIPE)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear M ...