Subaru Crosstrek Service Manual: Engine control module (ecm) i/o signal

Check cruise indicator light and cruise set indicator light

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostics with PhenomenonCHECK CRUISE INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHTTROUBLE SYMPTOM:Cruise control can be set, but the CRUISE indicator and S ...

Electrical specification

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Engine Control Module (ECM) I/O SignalELECTRICAL SPECIFICATIONFor details on the input/output signals for the engine control module, refer to ENGINE (DIAGNOSTI ...

Other materials:

Basic diagnostic procedure Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK PRE-INSPECTION.1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview">2) Before performing diagnostics, check the following ...

Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...

Removal
SECURITY AND LOCKS > Front Inner RemoteREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the screw, and remove the remote assembly - door.CAUTIO ...