Subaru Crosstrek Service Manual: Electrical specification
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O Signal
ELECTRICAL SPECIFICATION
1. RADAR SENSOR
Terminal No. | Content | Measuring condition | Standard | |
Radar sensor LH (master) | Radar sensor RH (slave) | |||
1 ←> Chassis ground | Private CAN H | Private CAN H | Always | 1 M? or more |
2 ←> Chassis ground | Master CAN H | — | Always | 1 M? or more |
3 ←> Chassis ground | — | — | — | — |
4 ←> Chassis ground | Left mirror LED output | Right mirror LED output | ||
• Ignition switch OFF > ON
• BSD/RCTA OFF switch OFF > ON
• When indicator is ON: 2.5 — 10.5 V
• When indicator is blinking: 0 ←> 2.5 — 10.5 V
• When indicator is OFF: Less than 1 V
5 ←> Chassis ground
Ignition power supply
Ignition power supply
Ignition switch OFF > ON
Less than 1 V > 9 — 16 V
6 ←> Chassis ground
Private CAN L
Private CAN L
Always
1 M? or more
7 ←> Chassis ground
Master CAN L
—
Always
1 M? or more
8 ←> Chassis ground
BSD/RCTA OFF switch
—
• Ignition switch ON
• BSD/RCTA OFF switch OFF > ON (while pressing and holding the switch)
Less than 1 V > 9 — 16 V
9 ←> Chassis ground
—
—
—
—
10 ←> Chassis ground
GND
GND
Always
Less than 1 ?
System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.&bu ...
Other materials:
General scan tool Operation
ENGINE (DIAGNOSTICS)(H4DO) > General Scan ToolOPERATION1. HOW TO USE GENERAL SCAN TOOL1. Prepare a scan tool (general scan tool) required by SAE J1978.2. Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver’s side).3. Using ...
Dtc u0164 lost communication with hvac control module
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0164 LOST COMMUNICATION WITH HVAC CONTROL MODULEDetected when CAN data is not received from A/C CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Dtc p0711 transmission fluid temperature sensor "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0711 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:&b ...