AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Control Module I/O Signal
ELECTRICAL SPECIFICATION
1. AUTO HEADLIGHT BEAM LEVELER CM
Content | Terminal No. | Measuring condition | Standard |
IG power supply | 1 ←> Chassis ground | Ignition switch ON | 8 — 16 V |
GND | 2 ←> Chassis ground | Always | Less than 1 ? |
Rr vehicle height sensor GND | 3 ←> Chassis ground | Always | Less than 1 ? |
Indicator output | 6 ←> Chassis ground | After turning the ignition switch to ON, for 3 seconds (warning light on) > after 3 seconds (warning light off) | Less than 1.35 V > 8 — 16 V |
Leveling actuator power supply | 10 ←> Chassis ground | Ignition switch ON | 10 — 16 V |
Leveling actuator GND | 11 ←> Chassis ground | Always | Less than 1 ? |
Rr vehicle height sensor power supply | 12 ←> 3 | Ignition switch ON | 4.75 — 5.25 V |
Leveling actuator signal | 17 ←> Chassis ground | Headlight off > on | Less than 1 V > 1.0 — 14.4 V (for 17 seconds) |
Headlight on, no vehicle height change > change and hold vehicle height for 3 seconds or more | |||
Rr sensor signal | 19 ←> Chassis ground | IG ON (with no passenger, no load and vehicle stopped) | Approx. 2.5 V (changes according to vehicle condition) |
CAN-H | 23 | Cannot be measured (CAN communication line) | — |
CAN-L | 24 | Cannot be measured (CAN communication line) | — |
Removal
COOLING(H4DO) > Radiator Sub Fan and Fan MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector from the sub fan motor assembly.4. Remove the bolts which hold the radiator sub fan sh ...
Dtc p0072 ambient air temperature sensor circuit "a" low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0072 AMBIENT AIR TEMPERATURE SENSOR CIRCUIT "A" LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearINSTALLATION1. Install the reduction driven gear assembly and spacer oil.Tightening torque:17 N·m (1.7 kgf-m, 12.5 ft-lb)2. Select the transfer drive gear shim. Reduction Drive Gear > ADJUSTMENT">3. Install the pa ...