SECURITY AND LOCKS > Keyless Entry System
ELECTRICAL SPECIFICATION
1. KEYLESS ENTRY CONTROL MODULE
• Model without tire pressure monitoring system
Terminal No. | Item | Measuring condition | Standard |
3 (U-ART com.) | — | Cannot be measured | — |
4 (+B) ←> Chassis ground | Voltage | Always | 10 — 14 V |
7 (GND) ←> Chassis ground | Resistance | Always | Less than 1 ? |
• Model with tire pressure monitoring system
Terminal No. | Item | Measuring condition | Standard |
4 (IG) ←> Chassis ground | Voltage | IG OFF > ON | 0 V > 10 — 14 V |
5 (GND) ←> Chassis ground | Resistance | Always | Less than 1 ? |
6 (+B) ←> Chassis ground | Voltage | Always | 10 — 14 V |
11 (U-ART com.) | — | Cannot be measured | — |
2. BODY INTEGRATED UNIT
Refer to “Control Module I/O Signal” of “BODY CONTROL SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">
Inspection
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof SwitchINSPECTION1. Check the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnector1 — 3OpenLess than 1 ?(b): Slide switch4 — 3CloseLess than 1 ?1 — 3Tilt upLess than 1 ?(a): ...
Inspection
COOLING(H4DO) > ThermostatINSPECTION1. Check that the thermostat does not have deformation, cracks or damage.2. Check that the thermostat valve closes completely at an ambient temperature.3. Immerse the thermostat and a thermometer in water. Raise water temperature gradually, and check the temper ...
Note
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionNOTE• The on-board diagnostic (OBD) system detects and indicates a fault in various inputs and outputs of the complex electronic control. Malfunction indicator light in the combination meter indicates occurrence of a fault or trouble.• F ...