Subaru Crosstrek Service Manual: Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O Signal
ELECTRICAL SPECIFICATION
CAUTION:
Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.
Terminal No. | Terminal name | Input/Output value | Note |
1 | Airbag CM communication (FSR+) | — | Communication line |
2 | Not used | — | — |
3 | Not used | — | — |
4 | Buckle switch − (BER−) | 0 V | Switch ground |
5 | Not used | — | — |
6 | IG power supply (IG) | 8 — 16 V | When ignition SW is ON |
7 | Not used | — | — |
8 | Buckle switch+ | 0 — IG voltage | Ignition voltage when the switch is ON |
9 | Airbag CM communication (FSR−) | 0 V | GND |
10 | Not used | — | — |
Wiring diagram
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “Occupant Detection System” in the wiring diagram. Occupant Detection System > WIRING DIAGR ...
Other materials:
Dtc c0033 fl hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0033 FL HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Forced drive
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidFORCED DRIVEIf the lid assembly - sunroof does not operate or the motor assembly is not supplied with power, move the lid assembly - sunroof using the hexagon wrench.Preparation tool:Hexagon wrench: width across flat 4 mm (0.16 in)CAUTION:After a ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessREMOVAL1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loos ...
