INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) System
ELECTRICAL SPECIFICATION
1. MULTI FUNCTION DISPLAY
• Standard type
Terminal No. | Item | Measuring condition | Standard |
1 (+B) ←> Chassis ground | Voltage | Always | 10 — 14 V |
2 (GND) ←> Chassis ground | Resistance | Always | Less than 1 ? |
3 (IG) ←> Chassis ground | Voltage | IG OFF > ON | 0 V > 10 — 14 V |
9 (U-ART com.) | — | Cannot be measured | — |
10 ←> Chassis ground | Voltage | Passenger’s airbag ON indicator light OFF > ON | 0 V > 1.5 V |
11 ←> Chassis ground | Voltage | Passenger’s airbag OFF indicator light OFF > ON | 0 V > 1.5 V |
• High grade type
Refer to “Control Module I/O Signal” of “INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS)” section. Control Module I/O Signal > ELECTRICAL SPECIFICATION">
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorINSPECTION1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor to data link connector.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, select «Diagnosis».(2) ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the radiator sub fan and fan motor assembly. Radiator Sub Fan and Fan Motor > REMOVAL">3. Lift up the vehicle.4. Remove the under cover. Front Under Cover > ...
Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...