Subaru Crosstrek Service Manual: Electrical component location Location
LAN SYSTEM (DIAGNOSTICS) > Electrical Component Location
LOCATION
(1) | VDC CM | (7) | Combination meter | (12) | Data link connector |
(2) | Power steering CM | (8) | A/C control panel | (13) | Transmission CM |
(3) | Stereo camera | (9) | MFD | (14) | Airbag CM |
(4) | Radar sensor LH | (10) | Data communication module (DCM) | (15) | Engine CM |
(5) | Auto headlight beam leveler CM | (11) | Body integrated unit | (16) | Keyless access CM |
(6) | Steering angle sensor |
Clear memory mode Operation
LAN SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed» ...
General diagnostic table Inspection
LAN SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONItemOperationSpecificationsNoteYESNODiagnostic codeDTC is displayed when inspecting all DTCs.Perform the diagnosis according to DTC.Syst ...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the hub ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)REMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the instrument panel lower cover. Instrument Panel Lowe ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSPECTION1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal No.Specified resistanc ...
