Subaru Crosstrek Service Manual: Electrical component location Location
EyeSight (DIAGNOSTICS) > Electrical Component Location
LOCATION
(1) | Stereo camera | (5) | EyeSight steering switch | (9) | Transmission control module (TCM) |
(2) | VDC control module (VDCCM) | (6) | MFD (multi-function display) | (10) | Stop light and brake switch |
(3) | Brake light relay | (7) | Body integrated unit | (11) | ECM |
(4) | Combination meter | (8) | Data link connector |
(1) | Adaptive cruise display | (6) | Lane indicator (left) | (11) | Steering wheel indicator |
(2) | Conventional cruise display | (7) | Preceding vehicle indicator | (12) | EyeSight temporary stop indicator |
(3) | READY indicator | (8) | Following distance setting indicator | (13) | EyeSight warning indicator |
(4) | OFF indicator | (9) | Lane indicator (right) | (14) | Lane departure warning OFF indicator light |
(5) | SET indicator | (10) | Set vehicle speed display | (15) | Pre-collision brake OFF indicator light |
(1) | Following distance setting switch | (3) | RES/+ (resume/plus) switch | (4) | SET/− (set/minus) switch |
(2) | CRUISE switch |
Clear memory mode Operation
EyeSight (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3 ...
Read current data Operation
EyeSight (DIAGNOSTICS) > Read Current DataOPERATION1. STEREO CAMERA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select ...
Other materials:
Assembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftASSEMBLYCAUTION:Wrap shaft splines with vinyl tape to protect the boot from scratches.NOTE:Use specified grease.Grease:BJ, EBJ side: NKG814DOJ side: NKG8141. Install the inner race to the shaft.(1) Install the boot (BJ) or boot (EBJ) in the specified position, ...
Engine oil
CAUTION
If the level gauge cannot be
pulled out easily, twist the level
gauge right and left, then gently
pull it out. Otherwise, you may be
injured accidentally straining
yourself.
Use only engine oil with the
recommended grade and viscosity.
Be careful not to spill engine oil
...
Enabling functions
When the procedure to disable the functions
is performed again, a chirp sound will
be heard, and the functions are enabled.
NOTE
The keyless access function will be
enabled only if you perform the procedure
in the same manner you disabled
the function (for example, when disabling
by o ...
