ENGINE (DIAGNOSTICS)(H4DO) > Electrical Component Location
LOCATION
1. CONTROL MODULE
(1) | Engine control module (ECM) | (3) | Malfunction indicator light | (4) | Data link connector |
(2) | Delivery (test) mode fuse |
2. SENSOR
(1) | Mass air flow and intake air temperature sensor | (5) | Crankshaft position sensor | (9) | Intake camshaft position sensor |
(2) | Tumble generator valve actuators (with built-in opening angle switch) | (6) | Knock sensor | (10) | Exhaust camshaft position sensor |
(3) | Electronic throttle control | (7) | Battery current sensor | (11) | Engine oil temperature sensor |
(4) | Manifold absolute pressure sensor | (8) | Battery temperature sensor | (12) | Engine coolant temperature sensor |
(1) | Front oxygen (A/F) sensor | (3) | Front catalytic converter | (4) | Rear catalytic converter |
(2) | Rear oxygen sensor |
(1) | Leak check valve ASSY (with built-in pressure sensor) | (2) | Fuel level sensor | (3) | Fuel sub level sensor |
3. SOLENOID VALVE, ACTUATOR, EMISSION CONTROL SYSTEM PARTS AND IGNITION SYSTEM PARTS
(1) | EGR control valve | (4) | Fuel injector | (6) | Tumble generator valve actuator |
(2) | Purge control solenoid valve | (5) | Ignition coil | (7) | Exhaust oil control solenoid |
(3) | Intake oil control solenoid |
(1) | Leak check valve ASSY | (2) | Canister |
(1) | Starter | (5) | Fuel pump relay | (9) | Radiator main fan relay 1 |
(2) | Fuel pump | (6) | A/F, oxygen sensor relay | (10) | Radiator main fan relay 2 |
(3) | Main relay | (7) | Electronic throttle control relay | (11) | Radiator sub fan relay |
(4) | IG relay | (8) | Starter relay 1 |
Assembly
CONTROL SYSTEMS > MT Gear Shift LeverASSEMBLYNOTE:• Clean all the parts before assembly.• Apply NIGTIGHT LYW No. 2 grease or equivalent to each part. General Description > COMPONENT">1. Mount the bushing and cushion rubber to the stay.(A)Bushing(B)Stay(C)Cushion rubber2. I ...
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearINSPECTION1. Move the reverse shifter rod toward the reverse side. Check the clearance between the reverse idler gear and the transmission case wall surface.If the value is out of specification, select the appropriate reverse shifter l ...
Removal
ENTERTAINMENT > Front SpeakerREMOVAL1. TWEETER1. Disconnect the ground cable from battery. NOTE">2. Remove the speaker assembly - tweeter.(1) Release the clips and claws, then detach the grille speaker side.NOTE:Remove the grille speaker side by using a plastic remover.(2) Remove the scr ...