Subaru Crosstrek Service Manual: Electrical component location Location
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Electrical Component Location
LOCATION
(1) | Engine control module (ECM) | (4) | Cruise indicator light and cruise set indicator light | (7) | Neutral position switch (MT model) |
(2) | Cruise control command switch | (5) | Transmission control module (TCM) (CVT model) | (8) | Clutch switch (MT model) |
(3) | Stop light and brake switch | (6) | Inhibitor switch (CVT model) |
Basic diagnostic procedure Procedure
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Before performing all diagnostics or cruise control diagnostics, always start the engine and make sure that ...
List of cancel code List
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > List of Cancel CodeLISTNOTE:• The cancel code is registered even when cancel is performed intentionally by the driver.• Cancel codes are cleared if ...
Other materials:
Dtc c0049 cruise controller abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0049 CRUISE CONTROLLER ABNORMALDTC detecting condition:Faulty signal is received from the stereo camera.Trouble symptom:• VDC may not operate.• EyeSight does not operate.STEPCHEC ...
Registration
For example, to register "32468" as the
PIN code, perform the following procedure.
1. Press the rear lock button three times.
2. After a buzzer (ding) sounds once,
press the rear lock button twice.
3. After a buzzer (ding) sounds once,
press the rear lock button four times.
4. After a ...
Removal
WIPER AND WASHER SYSTEMS > Rear WasherREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.3. Remove the roof spoiler ...
