Subaru Crosstrek Service Manual: Electrical component location Location
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Electrical Component Location
LOCATION
1. CONTROL MODULE
(1) | Transmission control module (TCM) | (3) | AWD light | (5) | Body integrated unit |
(2) | AT OIL TEMP light | (4) | Engine control module (ECM) | (6) | Data link connector |
2. SENSOR
(1) | Secondary speed sensor | (3) | Primary speed sensor | (5) | Inhibitor switch |
(2) | Turbine speed sensor | (4) | Secondary pressure sensor |
3. SOLENOID
(1) | Secondary solenoid | (3) | Lock-up duty solenoid | (5) | Primary UP solenoid |
(2) | AWD solenoid | (4) | Primary DOWN solenoid | (6) | F&R solenoid |
Drive cycle Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Drive CyclePROCEDUREIt is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform ...
Inspection mode Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Inspection ModePROCEDURE Road Test"> ...
Other materials:
Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
2. Slide the rear combination light as-
11-38
sembly rearward and remove it from the
vehicle.
Rear side marker light
Rear turn signal light
Backup light
Sto ...
Dtc b2810 incompatible with eyesight (combination meter)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2810 INCOMPATIBLE WITH EyeSight (COMBINATION METER)Detected when the combination meter, which is not designed exclusively for EyeSight is installed.DTC DETECTING CONDITION:Incorrect specifications of combination ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSPECTION1. Check that the oil control solenoid has no deformation, cracks or other damages.2. Measure the resistance between the oil control solenoid terminals.Terminal No.Standard1 and 27.25±0.4 ? (when 20°C (68°F ...
