CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0401 INVALID DATA RECEIVED FROM ECM/PCM “A”
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when data received from ECM is not normal.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from ECM | Did not change |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc u0164 lost communication with hvac control module
Dtc u0416 invalid data received from vehicle dynamics control moduleSafety precautions
CAUTION
People with delicate skin may
suffer slight burns even at low
temperatures if they use the seat
heater for a long period of time.
When using the heater, always be
sure to warn the persons concerned.
Do not put anything on the seat
which insulates against heat,
such as a ...
List of diagnostic trouble code (dtc) List
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContent of diagnosisReferenceB1650OCCUPANT DETECTION SYSTEM MALFUNCTION• Occupant detection sensor is faulty.• Occupant detection control module is faulty.• Occupant detection harness is fa ...
Except U.S.-spec. models (type A)
The illustration above is a typical example. For some models, the combination
meter
may be slightly different than that shown in the illustration.
Tachometer
Trip meter and odometer
Select lever/gear position indicator
Speedometer
Information display selection knob
ECO gauge
F ...