Subaru Crosstrek Service Manual: Dtc u0140 lost communication with body control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULE
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when CAN communication failure occurs with the body integrated unit.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from BIU | Lost |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc u0122 lost communication with vehicle dynamics control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULENOTE:Refer to “LAN S ...
Dtc p0500 vehicle speed sensor "a" circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at ...
Other materials:
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidINSTALLATION1. GLASS LID1. Using a new TORX® bolt, install the lid assembly - sunroof.Tightening torque:4.5 N·m (0.46 kgf-m, 3.3 ft-lb)2. Perform the open/close operation checks for the glass lid.3. Check the height of the lid assembly - ...
Inspection
LIGHTING SYSTEM > Luggage Room LightINSPECTION1. LUGGAGE ROOM LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it is found defective.2. LUGGAGE ROOM LIGHT SWITCH1. Check the resistance betwee ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > FRESH/RECIRC Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the FRESH/RECIRC switch to check that the link operates normally.3. If it does not operate normally as t ...
