Subaru Crosstrek Service Manual: Dtc u0122 lost communication with vehicle dynamics control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULE
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when CAN communication with VDCCM is not possible.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from Vehicle Dynamics Control Module | Lost |
Time Needed for Diagnosis: 0.5 seconds
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc u0100 lost communication with ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (D ...
Dtc u0140 lost communication with body control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGN ...
Other materials:
Dtc b14e5 mode door actuator stepping motor circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E5 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPENDTC detecting condition:Mode door actuator stepping motor circuit is open.Trouble symptom:Vent does not change.Wiring diagram:Air conditioning syst ...
Dtc b1675 satellite safing sensor failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1675 SATELLITE SAFING SENSOR FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Satellite safing sensor is faulty.• Airbag control module is faulty.CAUTION:Before performing d ...
Installation
MECHANICAL(H4DO) > Cylinder HeadINSTALLATION1. CYLINDER HEAD RH1. Clean the bolt holes in the cylinder block RH.CAUTION:To avoid erroneous tightening of the bolts, clean out the bolt holes sufficiently by blowing with compressed air to eliminate engine coolant etc.2. Apply liquid gasket to both s ...
