ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0101 LOST COMMUNICATION WITH TCM
NOTE:
For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
Detect malfunction of CAN communication.
Judge as NG when CAN communication failure between TCM, VDC CM and combination meter has occurred.
2. COMPONENT DESCRIPTION
(Common Specifications)
CAN Protocol 2.0 B (Active)
Frame Format: 11 Bit ID Frame (Standard Frame)
Conforms to ISO11898
Communication Speed: 500 kbps
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
Battery voltage | ≥ 10.9 V |
4. GENERAL DRIVING CYCLE
Perform the diagnosis continuously after starting the engine.
5. DIAGNOSTIC METHOD
Judge as NG when the following conditions are established.
Malfunction Criteria | Threshold Value |
CAN data from TCM | = Lost |
Time Needed for Diagnosis: 500 ms
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc p1531 battery current sensor circuit high
Dtc p0125 insufficient coolant temperature for closed loop fuel controlInstallation of child restraint systems by use of lower and tether
anchorages (LATCH)
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...
Dtc c1423 different ecu specifications
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1423 DIFFERENT ECU SPECIFICATIONSDTC detecting condition:Different control module specificationTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start as ...
Display
Touch screen
HOME icon
Status bar
Information bar
Main screen
Driver profiles icon
Manage device icon
Climate control screen
Car settings icon
In the Subaru Ascent, the advanced touch panel becomes fully operational when
the ignition switch is set to the "ACC" ...