Subaru Crosstrek Service Manual: Dtc u0100 lost communication with ecm/pcm a
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”
Detected when CAN data from ECM does not arrive.
NOTE:
Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE">
Dtc b2a02 tel2 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A02 TEL2 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:A ...
Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignit ...
Other materials:
Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...
Installation
SECURITY AND LOCKS > Rear Outer HandleINSTALLATION1. Before installation, check the following items.• Lever is free from deformation.• Grease is applied sufficiently to lever joints.If grease is insufficient, add it as necessary before assembling.• If the lever is faulty, replac ...
Inspection
ENTERTAINMENT > Diagnostics with PhenomenonINSPECTION1. POWER WILL NOT TURN ONWiring diagram:• Audio system: Audio System > WIRING DIAGRAM">• Navigation system: Navigation System > WIRING DIAGRAM">STEPCHECKYESNO1.CHECK CONNECTOR CONNECTION.Check that the connec ...
