ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P2109 THROTTLE/PEDAL POSITION SENSOR "A" MINIMUM STOP PERFORMANCE
NOTE:
For the diagnostic procedure, refer to DTC P2101. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P2101 THROTTLE ACTUATOR "A" CONTROL MOTOR CIRCUIT RANGE/PERFORMANCE">
1. OUTLINE OF DIAGNOSIS
Judge as NG when full close point learning cannot conducted or abnormal value is detected.
2. COMPONENT DESCRIPTION
(1) | Engine control module (ECM) | (3) | Motor | (4) | Throttle position sensor |
(2) | Drive circuit |
3. EXECUTION CONDITION
Secondary parameters | Execution condition |
Minimum stop position | < −4.020% or > −4.020% |
| Throttle default position − Throttle minimum stop position | | < 1.162 ° |
4. GENERAL DRIVING CYCLE
Perform the diagnosis at full closed point learning.
5. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
12 V battery system voltage | < 6 V |
Time Needed for Diagnosis: 8 ms — 80 ms
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Remote transmitter program (models without "keyless access with push-button
start system")
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed accord-ing to the follo ...
Dtc b280f combination meter malfunction
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B280F COMBINATION METER MALFUNCTIONMalfunction is detected in the combination meter.DTC DETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM:• All functions of EyeSight system do not operate.• ...
Basic procedures
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC PROCEDURES1. GENERAL DESCRIPTIONThe most important purpose of diagnostics is to quickly determine which part is malfunctioning, to save time and labor.2. IDENTIFICATION OF TROUBLE SYMPTOMDetermine what the problem is based on the symptom.3. PROBABLE ...