Subaru Crosstrek Service Manual: Dtc p170a l-range switch

Subaru Crosstrek Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p170a l-range switch

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P170A L-RANGE SWITCH

DTC DETECTING CONDITION:

Immediately at fault recognition

NOTE:

Refer to “DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE” for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE">

1. OUTLINE OF DIAGNOSIS

• Detect the GND-output short (ground-fault) in L range SW circuit.

• Judge as NG if the L range SW is ON in P, R or N range.

2. EXECUTION CONDITION

Secondary parameters	Execution condition
None

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
L range SW status in other than D range	ON

Time Needed for Diagnosis: 5 s

Malfunction Indicator Light Illumination: Does not illuminate.

Dtc u1433 invalid data received from eyesight

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1433 INVALID DATA RECEIVED FROM EyeSightNOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)& ...

Dtc u0100 lost communication with ecm/pcm a

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (D ...

Other materials:

General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back-up light does not illuminate.Adjust the select cable and inhibitor switch, or inspect the circuit.A ...

Basic diagnostic procedure Procedure
EyeSight (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Start the diagnosis after the engine has started. (Cruise control main switch does not turn on even if it is pressed before the engine starts.)• When performing diagnosis, observe the legal speed limit on the road.& ...

Installation
AIRBAG SYSTEM > Front Door Impact SensorINSTALLATIONCAUTION:Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.1. Before installation, inspect the following items and replace any faulty part with a new part.• The front door impact sensor or connector is damag ...