Subaru Crosstrek Service Manual: Dtc p160a random access memory (ram) error

Subaru Crosstrek Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p160a random access memory (ram) error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P160A RANDOM ACCESS MEMORY (RAM) ERROR

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM RAM malfunction

STEP	CHECK	YES	NO

1.CHECK DTC.

1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode">

2) Read the DTC.

Is DTC P160A displayed?

Replace the TCM. Transmission Control Module (TCM)">

Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

• Detect the malfunction in RAM area of the TCM.

• Judge as NG if an attempt to write to RAM area failed.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
12 V battery system voltage	≥ 9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Writing-check (RAM) NOTE:

Malfunction Criteria

Threshold Value

Writing-check (RAM)

NOTE:

This check is carried out about the RAM used except for CAN communication.

Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p0977 shift solenoid "b" control circuit high

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0977 SHIFT SOLENOID "B" CONTROL CIRCUIT HIGHDTC detecting condition:Immediat ...

Dtc p2746 intermediate shaft speed sensor "b" circuit range/performance

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2746 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT RANGE/PERFORMANCEDTC detect ...

Other materials:

Installation
SEAT BELT SYSTEM > Front Seat BeltINSTALLATION1. SEAT BELT OUTER - FRONTCAUTION:• The parts of the driver and passenger sides are not the same. Before installation, make sure that the correct part is used.• During installation, make sure that the seat belts are not twisted.• Aft ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AT OIL TEMP Warning Light DisplayINSPECTIONDIAGNOSIS:• CAN communication is lost with the combination meter.• Combination meter malfunction• TCM is in special control mode.• AT learning is not finished.TROUBLE SYMPTOM:&bul ...

Shifting speeds
Recommended shifting speeds The best compromise between fuel economy and vehicle performance during normal driving is ensured by shifting up at the speeds listed in the following table. Maximum allowable speeds The following table shows the maximum speeds that are possible with each differe ...