Subaru Crosstrek Service Manual: Dtc p062f internal control module eeprom error

Subaru Crosstrek Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc p062f internal control module eeprom error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P062F INTERNAL CONTROL MODULE EEPROM ERROR

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM EEPROM malfunction

STEP	CHECK	YES	NO

1.CHECK DTC.

1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode">

2) Read the DTC.

Is DTC P062F displayed?

Replace the TCM. Transmission Control Module (TCM)">

Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

Diagnosis 1

• Detect the malfunction in EEPROM area of the TCM.

• Judge as NG if an attempt to write to EEPROM area failed.

Diagnosis 2

• Detect the malfunction in EEPROM area of the TCM.

• Judge as malfunction when the consistency in the EEPROM area is lost.

2. EXECUTION CONDITION

Secondary Parameters	Execution condition
Diagnosis 1
12 V battery system voltage	≥ 9 V
Diagnosis 2
12 V battery system voltage	≥ 9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria	Threshold Value
Diagnosis 1
Writing-check (EEPROM)	Error
Diagnosis 2
Checksum (EEPROM)	Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p0604 internal control module random access memory (ram) error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERRORDTC DETECTING CONDITION:D ...

Dtc p2530 ignition switch run position circuit

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault ...

Other materials:

Headlights (models without HID headlights)
CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spots, causing the bulb to break. If there are finger prints or grease on the bulb surface, wipe the ...

Electrical component location Location
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Combination meter(2)MFD(3)Data link connector ...

Recommended tire inflation pressure
Recommended cold tire inflation pressure For recommended cold tire inflation pressure for your vehicle's tires, refer to "Tires" F12-8. Vehicle placard The vehicle placard is attached to the driver's side door pillar. Example: The vehicle placard shows original tire size, recommended ...