ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCE
NOTE:
For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCESSOR">
1. OUTLINE OF DIAGNOSIS
Judge as NG when the monitoring IC operation is abnormal. (Monitoring IC malfunction)
2. COMPONENT DESCRIPTION
(1) | Throttle position sensor | (6) | Accelerator pedal position sensor 2 | (10) | CPU |
(2) | Throttle position sensor 1 | (7) | I/F circuit | (11) | Monitoring IC |
(3) | Throttle position sensor 2 | (8) | Amplifier circuit | (12) | EEPROM |
(4) | Accelerator pedal position sensor | (9) | Engine control module (ECM) | (13) | Output IC |
(5) | Accelerator pedal position sensor 1 |
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
(1) Battery voltage | ≥ 6 V |
(1) CPU intentionally sends a motor cut-off command to the observation IC | ON |
(2) Battery voltage | ≥ 6 V |
(2) CPU intentionally sends an incorrect data | ON |
(3) Battery voltage | ≥ 6 V |
4. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.
5. DIAGNOSTIC METHOD
Judge as OK and clear the NG when the malfunction criteria below are met.
Malfunction Criteria | Threshold Value |
(1) Throttle position Memory throttle position when monitoring | ≥ 2 ° |
(2) Motor cut-off signal from observation IC | = Not Detected |
(3) Written data in the observation IC register | ≠ Not Detected |
Time Needed for Diagnosis:
(1): 24 ms
(2): 24 ms
(3): 200 ms
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Inspection
LIGHTING SYSTEM > Day Time Running ResistorINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsSpecificationConnection diagram1 — 2Always1.13±0.05 ?2. Replace the resistor assembly - daytime running light if the inspec ...
Head restraint height adjustment
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head ...
Installation
LIGHTING SYSTEM > Auto Headlight Beam Leveler Control ModuleINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the rev ...