Subaru Crosstrek Service Manual: Dtc p0604 internal control module random access memory (ram) error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERROR
DTC DETECTING CONDITION:
Immediately at fault recognition
TROUBLE SYMPTOM:
• Engine does not start
• Engine stall
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">
, and Inspection Mode Inspection Mode > PROCEDURE">.
| STEP | CHECK | YES | NO |
1.CHECK FOR ANY OTHER DTC ON DISPLAY.
Is any other DTC displayed?
Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">
Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
1. OUTLINE OF DIAGNOSIS
Detect the malfunction of microcomputer (RAM).
If it is possible to write data to the whole area of RAM in the initial routine, and is possible to read the same data, it is judged as OK, and if not, NG.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
None |
Diagnosis with the initial routine.
3. GENERAL DRIVING CYCLE
Perform the diagnosis as soon as the ignition switch is turned to ON.
4. DIAGNOSTIC METHOD
Judge as NG when the following conditions are established.
Malfunction Criteria | Threshold Value |
Write the specified value into the RAM. | The written value cannot be read. |
Time Needed for Diagnosis: Less than 0.512 seconds
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc p0512 starter (switch) request circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0512 STARTER (SWITCH) REQUEST CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom ...
Dtc p0605 internal control module read only memory (rom) error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0605 INTERNAL CONTROL MODULE READ ONLY MEMORY (ROM) ERRORNOTE:For the diagnostic procedure, refer to DTC P06 ...
Other materials:
Refrigerant recovery procedure Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Recovery ProcedurePROCEDURECAUTION:• During operation, be sure to wear protective goggles and protective gloves.• Connect the refrigerant recovery system with the manifold gauge set to discharge the refrigerant from the A/C system ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialASSEMBLYInstall the ball bearings.CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Use a new ball bearing.(A)Ball bearing ...
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > VDC OFF SwitchINSPECTION1. Disconnect the VDC OFF switch connector.2. Check the resistance between the VDC OFF switch terminals.PREPARATION TOOL:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?3. Replace th ...
