Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc p0601 internal control module memory checksum error

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0601 INTERNAL CONTROL MODULE MEMORY CHECKSUM ERROR

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:

TCM ROM malfunction

STEPCHECKYESNO

1.CHECK DTC.

1) Perform the Clear Memory Mode using the Subaru Select Monitor. Clear Memory Mode">

2) Read the DTC.

Is DTC P0601 displayed?

Replace the TCM. Transmission Control Module (TCM)">

Current condition is normal. Check for interference from noise, etc.

1. OUTLINE OF DIAGNOSIS

Detect the malfunction in ROM area of the TCM.

Judge as NG when the consistency in the ROM area is lost.

2. EXECUTION CONDITION

Secondary Parameters

Execution condition

12 V battery system voltage

≥ 9 V

3. DIAGNOSTIC METHOD

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

Judgment Value

Malfunction Criteria

Threshold Value

Checksum (ROM)

Error

Time Needed for Diagnosis: Immediately

Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.

Dtc p2530 ignition switch run position circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault ...

Dtc p0705 transmission range sensor "a" circuit (prndl input)
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0705 TRANSMISSION RANGE SENSOR "A" CIRCUIT (PRNDL INPUT)DTC detecting condit ...

Other materials:

Dtc b2810 incompatible with eyesight (combination meter)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2810 INCOMPATIBLE WITH EyeSight (COMBINATION METER)Detected when the combination meter, which is not designed exclusively for EyeSight is installed.DTC DETECTING CONDITION:Incorrect specifications of combination ...

Switching power status
Operation indicator Push-button ignition switch The power status is switched every time the push-button ignition switch is pressed. 1. Carry the access key, and sit in the driver's seat. 2. Shift the select lever into the "P" position. 3. Press the push-button ignition switch ...

Rocking the vehicle
If you must rock the vehicle to free it from snow, sand, or mud, depress the accelerator pedal slightly and move the shift lever/select lever back and forth between "1"/"D" and "R" repeatedly. Do not race the engine. For the best possible traction, avoid spinning the wheels when trying to fr ...

© 2016-2022 Copyright www.sucross.com