Subaru Crosstrek Service Manual: Dtc p0500 vehicle speed sensor "a" circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUIT
DTC DETECTING CONDITION:
Immediately at fault recognition
TROUBLE SYMPTOM:
VDC does not operate.
| STEP | CHECK | YES | NO |
1.CHECK DTC.
Read the DTC of VDC system using the Subaru Select Monitor.
Is DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Repair the poor contact of connector and harness between VDCCM&H/U and wheel speed sensor.
1. OUTLINE OF DIAGNOSIS
• Detect the malfunction of VDC wheel speed sensor.
• Judge as NG when the wheel speed sensor normal status signal from VDC is cleared.
2. EXECUTION CONDITION
Secondary Parameters | Execution condition |
12 V battery system voltage | ≥ 10.9 V |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
Signal of malfunction from Vehicle Dynamics Control Module NOTE: |
The VDC controller detects malfunction if one of the speed sensors does not output a signal and the other vehicle speed sensor output signal is above 7.46 MPH.
ON
Time Needed for Diagnosis: 2.5 seconds
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc u0140 lost communication with body control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGN ...
Dtc p0604 internal control module random access memory (ram) error
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERRORDTC DETECTING CONDITION:D ...
Other materials:
Continuously variable transmission
WARNING
Do not shift from the "P" or "N"
position into the "D" or "R" position
while depressing the accelerator
pedal. This may cause the vehicle
to jump forward or backward.
CAUTION
Observe the following precautions.
Failure to observe these
precautions could cause damage
to the transmi ...
Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignition switch is ON, VIN information (CAN) sent from ECM cannot be read.Trouble symptom:• Telemat ...
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchDISASSEMBLY1. Remove the snap ring, and then remove the pressure plate, drive plate and driven plate.(A)Snap ring2. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL(A)Snap ring(B)Tran ...
