ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0341 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 1 OR SINGLE SENSOR
NOTE:
For the diagnostic procedure, refer to DTC P0340. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0340 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 1 OR SINGLE SENSOR">
1. OUTLINE OF DIAGNOSIS
Detect the malfunction of camshaft position sensor property.
Judge as NG when the number of camshaft signals remains abnormal.
2. COMPONENT DESCRIPTION
(A) | Camshaft signal (RH) | (B) | Camshaft signal (LH) | (C) | Crankshaft signal |
(D) | Camshaft position signal: When normal, there will be 3 camshaft position signals for every 2 crankshaft revolutions. |
3. EXECUTION CONDITION
Secondary Parameters | Execution condition |
Battery voltage | ≥ 8 V |
Elapsed time after starting the engine | ≥ 200 ms |
4. GENERAL DRIVING CYCLE
Always perform the diagnosis continuously.
5. DIAGNOSTIC METHOD
Judge as NG when the status where the number of camshaft position sensor signal in two crankshaft revolutions is other than 3 time(s).
Malfunction Criteria | Threshold Value |
Amount of camshaft sensor signal during 2 revs of crankshaft | ≠ 3 time(s) |
Time Needed for Diagnosis: Two engine revs. ? 4 time(s)
Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.
Dtc c2224 transmitter 4 pressure data abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2224 TRANSMITTER 4 PRESSURE DATA ABNORMALDTC DETECTING CONDITION:Detected when error data is received from each transmitter at a vehicle speed of 40 km/h (25 MPH) or more.• When compa ...
Rear Cross Traffic Alert (RCTA)
Operating range
The system notifies the driver of another
vehicle approaching from either side when
driving in reverse. This feature helps the
driver check the rear and side areas of the
vehicle when moving backward.
If the system detects a vehicle approaching
from either side whil ...
Removal
SECURITY AND LOCKS > Front Outer HandleREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">3. Remove the trim panel - front door. Door Trim > REMOVAL">4. R ...