ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0125 INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP FUEL CONTROL
DTC detecting condition:
Detected when two consecutive driving cycles with fault occur.
Trouble symptom:
Engine does not return to idle.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > PROCEDURE">.
STEP | CHECK | YES | NO |
1.CHECK ENGINE COOLANT.
Check the following items:
• Amount of engine coolant
• Engine coolant freeze
• Contamination of engine coolant
Is the check result OK?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0125 INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP FUEL CONTROL">Go to Step 2.
Fill or replace the engine coolant. Engine Coolant > REPLACEMENT">
2.CHECK THERMOSTAT.
Does the thermostat remain opened?
Replace the thermostat. Thermostat">
Replace the engine coolant temperature sensor. Engine Coolant Temperature Sensor">
1. OUTLINE OF DIAGNOSIS
Detect the malfunction of engine coolant temperature output property.
Judge as NG when engine coolant temperature does not rise to the specified value after predetermined time has elapsed since engine start.
2. COMPONENT DESCRIPTION
(A) | Resistance value (k?) | (B) | Temperature °C (°F) | ||
(1) | Connector | (2) | Thermistor element |
3. EXECUTION CONDITION
Secondary parameters | Execution condition |
Battery voltage | ≥ 10.9 V |
Engine speed | ≥ 500 rpm |
Engine coolant temperature at engine start | < −15 °C (5 °F) |
4. GENERAL DRIVING CYCLE
Perform the diagnosis only once after starting the engine from cold condition.
5. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
Engine coolant temperature | < −15 °C (5 °F) |
Elapsed time after starting the engine | |
(At the time of (The smaller value of either Engine coolant temperature or Intake air temperature at engine start) ≥ −23.3°C (−9.9°F)) | ≥ 120 s |
or | |
(At the time of (The smaller value of either Engine coolant temperature or Intake air temperature at engine start) < −23.3°C (−9.9°F)) | ≥ 300 s |
Time needed for diagnosis: Less than 1 second
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Torque Converter AssemblyINSTALLATION1. Install the O-ring to the input shaft.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.NOTE: ...
Remote start safety features
For safety and security reasons, the
remote engine start system will prevent
starting (or stop the engine if running) and
sound the horn twice if any of the following
conditions is detected. In addition, the fob
will flash and beep 3 times.
The brake pedal is depressed
A key is in the ign ...
Dtc b1577 imm control module eeprom
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1577 IMM CONTROL MODULE EEPROM1. EXCEPT FOR C0 AND C5 MODELSDTC detecting condition:• Defective keyless access CM• When inaccessible to ROM in keyless access CM.STE ...