ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P000A "A" CAMSHAFT POSITION SLOW RESPONSE BANK 1
NOTE:
For the diagnostic procedure, refer to DTC P0011. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0011 "A" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 1">
1. OUTLINE OF DIAGNOSIS
Detect the AVCS system malfunction.
Judge NG when the amount of AVCS actual timing advance does not approach to the amount of AVCS target timing advance.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
Battery voltage | ≥ 10.9 V |
AVCS control | In operation |
|Target timing advance change amount (per 64 ms)| | < 3.2 °CA |
3. GENERAL DRIVING CYCLE
Perform the diagnosis continuously when the engine speed increases and AVCS operates.
4. DIAGNOSTIC METHOD
When the differences of target timing advance amount and actual timing advance amount is calculated during AVCS control, and the difference per predetermined time is the specified value or larger.
Judge as NG when the following conditions are established within the predetermined time.
Malfunction Criteria | Threshold Value |
Σ|(Target position − Actual position)| | > 4000 °CA (Bank 1) > 4000 °CA (Bank 2) |
Time needed for diagnosis: Less than 1 second
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
Dtc c0041 parameter selection error
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0041 PARAMETER SELECTION ERRORDTC DETECTING CONDITION:VDCCM parameter selection errorTROUBLE SYMPTOM:• ABS does not operate.• EBD does not operate.• VDC does not operate.&b ...
Cup holders
CAUTION
Do not pick up a cup from the cup
holder or put a cup in the holder
while you are driving, as this may
distract you and lead to an
accident.
Take care to avoid spills. Beverages,
if hot, might scald you
and/or your passengers. Spilled
beverages may also damage upholstery
...
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...