Subaru Crosstrek Service Manual: Dtc c2551 power supply relay

Trouble symptom:

• The steering wheel operation feels heavy.

• STEERING warning light illuminates.

If power supply voltage failure exists at the vehicle side, the warning light goes off if the normal voltage returns.

1.CHECK BATTERY.

Check the battery. Battery > INSPECTION">

Is the check result OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2551 POWER SUPPLY RELAY">Go to Step 2.

Charge or replace the battery.

2.CHECK BATTERY TERMINALS AND FUSE.

Check the battery terminals and the fuse.

Is the check result OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2551 POWER SUPPLY RELAY">Go to Step 3.

Repair or replace faulty parts.

3.CHECK WIRING HARNESS.

1) Disconnect the connector of the power steering control module.

2) Turn the ignition switch to ON.

3) Using a tester and test harness, check the voltage between terminals.

Connector & terminal

(B452) No. 2 (+) — Chassis ground (−):

Is the voltage 12 V or more?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2551 POWER SUPPLY RELAY">Go to Step 4.

Repair the open circuit of harness or the poor contact of connector between the power steering control module and the battery.

4.CHECK GROUND CIRCUIT.

1) Turn the ignition switch to OFF.

2) Using a tester and test harness, check the resistance between terminals.

Connector & terminal

(B452) No. 1 — Chassis ground:

Is the resistance less than 1 ??

Check for poor contact of terminals in the power steering control module, and if there are no malfunctions, replace the power steering control module. Power Steering Control Module">

Repair the open circuit or poor contact of the harness between the power steering control module and chassis ground.

Dtc c2543 error passive

Dtc u0416 invalid data received from vehicle dynamics control module

Other materials:

Installation
SEATS > Rear SeatINSTALLATIONInstall each part in the reverse order of removal.NOTE:• After installing the backrest assembly, make sure that each seat belt operates normally.• Make sure that they are properly secured on each hook on the vehicle side.Tightening torque:Refer to “C ...

Replacement
SECURITY AND LOCKS > Ignition Key LockREPLACEMENTCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• If the steering wheel and steering ...

Seatbelt safety tips
WARNING All persons in the vehicle should fasten their seatbelts BEFORE the vehicle starts to move. Otherwise, the possibility of serious injury becomes greater in the event of a sudden stop or accident. All belts should fit snugly in order to provide full restraint. Loose fittin ...