POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC C2514 TORQUE SENSOR POWER SUPPLY
Trouble symptom:
• The steering wheel operation feels heavy.
• STEERING warning light illuminates.
Wiring diagram:
Electric power steering system Electric Power Steering System">
STEP | CHECK | YES | NO |
1.CHECK TORQUE SENSOR SIGNAL.
1) Display the current data of the power steering control module using the Subaru Select Monitor.
2) Check the voltage of «Torque sensor main output», «Torque sensor sub output», «Torque sensor reference voltage» and «Torque sensor power supply voltage».
Are the voltage of «Torque sensor main output» and «Torque sensor sub output» 2.5±0.1 V?
Is the voltage of «Torque sensor reference voltage» 3±0.1 V?
Is the voltage of «Torque sensor power supply voltage» 8±0.4 V?
Check for poor contact of the connector, and check the conditions again. If the condition recur, go to the next step. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2514 TORQUE SENSOR POWER SUPPLY">Go to Step 2.
If it does not recur, complete the inspection.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2514 TORQUE SENSOR POWER SUPPLY">Go to Step 2.
2.CHECK HARNESS.
1) Turn the ignition switch to OFF.
2) Disconnect the connector (B451).
3) Using a tester and test harness, check the internal resistance of the harness terminals.
Connector & terminal
(B450) No. 4 — (B451) No. 3:
(B450) No. 5 — (B451) No. 5:
(B450) No. 8 — (B451) No. 1:
(B450) No. 9 — (B451) No. 2:
(B450) No. 10 — (B451) No. 4:
Is the resistance less than 10 ??
Replace the power steering control module. Power Steering Control Module">
Repair or replace the harness.
Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Set the tire to the straight ...
Checking the coolant level
WARNING
Never attempt to remove the radiator
cap until the engine has been
shut off and has cooled down
completely. Since the coolant is
under pressure, you may suffer
serious burns from a spray of boiling
hot coolant when the cap is
removed.
"FULL" level mark
"LOW" level mark
C ...
Basic diagnostic procedure Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Basic Diagnostic ProcedurePROCEDURE1. ENGINESTEPCHECKYESNO1.CHECK ENGINE START FAILURE.1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview > CHECK">2) Start the engine.Does the engine start? Basic ...