Subaru Crosstrek Service Manual: Dtc c2024 tire 4 air pressure low (normal mode)

DTC DETECTING CONDITION:

Inflation pressure of tires dropped below the specified value.

NOTE:

For the specifications, refer to “CURRENT DATA”. Read Current Data > LIST">

1.CHECK TIRES.

Lift up the vehicle and check for damage in the tires.

Are there cracks or damage?

Replace the tire.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2024 TIRE 4 AIR PRESSURE LOW (NORMAL MODE)">Go to Step 2.

2.CHECK TIRES.

Check the tire air pressure.

Is the tire pressure in the specifications?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2024 TIRE 4 AIR PRESSURE LOW (NORMAL MODE)">Go to Step 3.

Adjust the air pressure.

3.CHECK TRANSMITTER DATA.

1) Drive at 40 km/h (25 MPH) or more.

2) Confirm the current data «Tire 1 air pressure»«Tire 2 air pressure»«Tire 3 air pressure»«Tire 4 air pressure» of the tire pressure monitor. Read Current Data">

Is there a transmitter with different display?

Replace the transmitter (tire pressure sensor) with different display. Tire Pressure Monitoring System">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2024 TIRE 4 AIR PRESSURE LOW (NORMAL MODE)">Go to Step 4.

4.PERFORM DRIVING TEST.

1) Perform the Clear Memory Mode. Clear Memory Mode > OPERATION">

2) Perform a driving test. Inspection Mode > PROCEDURE">

3) Read the DTC of tire pressure monitoring. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the TPMS & keyless entry CM or TPMS CM. Tire Pressure Monitoring System">

Even if the DTC is displayed, the system has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

When driving vehicle to perform driving test, there should be always 2 persons (driver and checker) to check.

Dtc c2023 tire 3 air pressure low (normal mode)

Dtc c2121 transmitter 1 no data

Other materials:

Seatbelt maintenance
To clean the seatbelts, use a mild soap and lukewarm water. Never bleach or dye the belts because this could seriously affect their strength. Inspect the seatbelts and attachments including the webbing and all hardware periodically for cracks, cuts, gashes, tears, damage, loose bolts or wor ...

Installation
AIRBAG SYSTEM > Side Airbag SensorINSTALLATIONCAUTION:Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.1. Before installation, inspect the following items and replace any faulty part with a new part.• The side airbag sensor, sensor bracket, or connector are ...

Adjustment
DIFFERENTIALS > Rear Differential (T-type)ADJUSTMENT1. SIDE GEAR BACKLASHAdjust the side gear backlash. Rear Differential (T-type) > ASSEMBLY">2. HYPOID DRIVEN GEAR BACKLASHAdjust hypoid driven gear backlash. Rear Differential (T-type) > ASSEMBLY">3. TOOTH CONTACT BETWEEN ...