Subaru Crosstrek Service Manual: Dtc c1431 at
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC C1431 AT
DTC detecting condition:
Defective TCM
Trouble symptom:
• ABS does not operate.
• VDC does not operate.
| STEP | CHECK | YES | NO |
1.CHECK TCM.
1) Start the engine.
2) Read the DTC of the TCM. Read Diagnostic Trouble Code (DTC)">
Are any DTCs displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1431 AT">Go to Step 2.
2.CHECK VDCCM&H/U.
1) Turn the ignition switch to OFF.
2) After turning the ignition switch to ON for approx. 10 seconds, turn it to OFF.
3) Turn the ignition switch to ON again.
4) Perform the Clear Memory Mode. Clear Memory Mode">
5) Perform the Inspection Mode. Inspection Mode">
6) Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is the same DTC displayed?
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1431 AT">Go to Step 3.
3.CHECK DETECTION OF OTHER DTCS FOR VDC.
Read Diagnostic Trouble Code (DTC)">
Is any other DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.
Dtc c1424 ecm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1424 ECMDTC detecting condition:ECM malfunctioningTrouble symptom:• ABS does not ope ...
Dtc c1531 bls off stuck
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1531 BLS OFF STUCKDTC detecting condition:Defective stop light switchTrouble symptom:&bull ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Propeller ShaftREMOVALCAUTION:• Before removing propeller shaft, wrap metal parts with a cloth or rubber material.• Do not disassemble the center EDJ of the propeller shaft.• Before removing propeller shaft, wrap the metal parts attached to the rubber boot o ...
Menu screens
Pull the "
/SET" switch to enter the menu
screens when all of the following conditions
are satisfied.
The vehicle has been completely
stopped.
The select lever is in the "P" position.
The menu screen entering screen is
selected.
The "
" information reminder is off.
Th ...
Dtc b1015 key interlock circuit
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1015 KEY INTERLOCK CIRCUITDTC detecting condition:Ground short of key interlock circuitTrouble symptom:Key interlock does not keep lock condition.Wiring diagram:Shift lock control system Shift Lock Co ...
