Subaru Crosstrek Service Manual: Dtc c1424 ecm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC C1424 ECM
DTC detecting condition:
ECM malfunctioning
Trouble symptom:
• ABS does not operate.
• VDC does not operate.
• Hill start assist does not operate.
| STEP | CHECK | YES | NO |
1.CHECK ECM.
1) Start the engine.
2) Read the DTC of the ECM. Read Diagnostic Trouble Code (DTC)">
Are any DTCs displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1424 ECM">Go to Step 2.
2.CHECK VDCCM&H/U.
1) Perform the Clear Memory Mode. Clear Memory Mode">
2) Perform the Inspection Mode. Inspection Mode">
3) Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is the same DTC displayed?
Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1424 ECM">Go to Step 3.
3.CHECK DETECTION OF OTHER DTCS FOR VDC.
Read Diagnostic Trouble Code (DTC)">
Is any other DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.
Dtc c1413 power supply voltage
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1413 POWER SUPPLY VOLTAGEDTC detecting condition:Improper VDCCM&H/U power supply volta ...
Dtc c1431 at
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1431 ATDTC detecting condition:Defective TCMTrouble symptom:• ABS does not operate.& ...
Other materials:
Dtc p0452 evap system (cpc) pressure sensor/switch circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0452 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...
Dtc b2a0b green led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0B GREEN LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at ...
Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSPECTION1. CHECK SWITCHING VALVE1. Check the resistance between switching valve terminals.Terminal No.Standard1 and 527+3 −2 ? (when 20°C (68°F))31±4 ? (60°C (140° ...
