Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc c1423 different ecu specifications

VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC C1423 DIFFERENT ECU SPECIFICATIONS

DTC detecting condition:

Different control module specification

Trouble symptom:

ABS does not operate.

VDC does not operate.

Hill start assist does not operate.

NOTE:

When parameter selection for VDCCM is improper, this DTC may be memorized.

STEPCHECKYESNO

1.CHECK VDCCM&H/U IDENTIFICATION SYMBOL.

Check the identification symbol attached on the H/U. General Description > SPECIFICATION">

Is the identification symbol correct?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 2.

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

2.CHECK PARAMETER SELECTED IN VDCCM.

Subaru Select Monitor > OPERATION">

Does the parameter registered in the VDCCM match the relevant vehicle?

CVT model: Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 3.
MT model: Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 5.

Select and register the correct parameter. Subaru Select Monitor > OPERATION">

3.CHECK TCM SPECIFICATION.

Check the TCM specification.

Is the specification of TCM same as vehicle specification?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 4.

Replace the TCM. Transmission Control Module (TCM)">

4.CHECK CVT SYSTEM.

1) Start the engine.

2) Read the DTC of the CVT system. Read Diagnostic Trouble Code (DTC)">

Is DTC of CVT system displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 5.

5.CHECK ECM SPECIFICATION.

Check the ECM specification.

Is the specification of ECM same as vehicle specification?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 6.

Replace the ECM. Engine Control Module (ECM)">

6.CHECK ENGINE SYSTEM.

1) Start the engine.

2) Read DTC of the engine system. Read Diagnostic Trouble Code (DTC)">

Is engine system DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 7.

7.CHECK VDCCM&H/U.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Perform the Inspection Mode. Inspection Mode">

3) Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the VDCCM only. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > REPLACEMENT">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1423 DIFFERENT ECU SPECIFICATIONS">Go to Step 8.

8.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)">

Is any other DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.

Dtc c1432 different ecu specifications
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1432 DIFFERENT ECU SPECIFICATIONSNOTE:For the diagnostic procedure, refer to “DTC C1 ...

Dtc c1731 g sensor abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1731 G SENSOR ABNORMALNOTE:For the diagnostic procedure, refer to “DTC C1732 LATERAL ...

Other materials:

Removal
WIPER AND WASHER SYSTEMS > Rear WasherREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.3. Remove the roof spoiler ...

Dtc b2779 remote control engine starter collation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2779 REMOTE CONTROL ENGINE STARTER COLLATIONDTC detecting condition:When the keyless access CM does not respond to engine start even when the remote control engine starter is O ...

Disassembly
CONTROL SYSTEMS > MT Gear Shift LeverDISASSEMBLY1. Remove the lock wires.(A)Lock wire2. Remove the rod from gear shift lever.(A)Rod(B)Lever(C)Stay3. Separate the rod and inner boot.4. Remove the snap ring from the stay.(A)Snap ring5. Separate the gear shift lever and the stay.6. Remove the boot a ...

© 2016-2024 Copyright www.sucross.com