Subaru Crosstrek Service Manual: Dtc c0057 vdc interrupted due to egi reason
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC C0057 VDC INTERRUPTED DUE TO EGI REASON
DTC DETECTING CONDITION:
Cooperation control prohibition of ECM
TROUBLE SYMPTOM:
• VDC does not operate.
• EyeSight does not operate.
NOTE:
• For the diagnostic procedure, refer to “DTC C0057 ECM CONTROL SYSTEM”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0057 ECM CONTROL SYSTEM">
• Warning lights go off if the cooperation control of ECM returns.
Dtc c0056 g sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0056 G SENSOR SIGNALDTC detecting condition:Longitudinal G sensor signal failureTrouble sy ...
Dtc c0071 no signal from steering angle sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0071 NO SIGNAL FROM STEERING ANGLE SENSORDTC detecting condition:Communication from steeri ...
Other materials:
Inspection
DIFFERENTIALS > Rear Differential (VA-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage or other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the sleeve and the gear and hub assembly by matching the alignment marks.NOTE:• Make sure that there is no large clearance at both sides of the 1st-2nd shifting insert after assembly.(A)1st-2nd shiftin ...
Inspection
BRAKE > Brake PedalINSPECTION1. Move the pad - brake pedal in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.CAUTION:If excessive deflection is noted, replace with a new bushing.Deflection of brake pedal:We ...
