VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC C0057 ECM COMMUNICATION CIRCUIT
DTC detecting condition:
No CAN signal from ECM.
Trouble symptom:
• VDC does not operate.
• EyeSight does not operate.
STEP | CHECK | YES | NO |
1.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. Basic Diagnostic Procedure">
Is there any fault in LAN system?
Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0057 ECM COMMUNICATION CIRCUIT">Go to Step 2.
2.CHECK POOR CONTACT OF CONNECTORS.
Is there poor contact of ECM connector?
Repair the connector.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0057 ECM COMMUNICATION CIRCUIT">Go to Step 3.
3.CHECK ECM.
Refer to the basic diagnostic procedure of ENGINE (DIAGNOSTICS).
Is the check result OK?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0057 ECM COMMUNICATION CIRCUIT">Go to Step 4.
Replace the ECM. Engine Control Module (ECM)">
4.CHECK VDCCM&H/U.
1) Connect all connectors.
2) Perform the Clear Memory Mode. Clear Memory Mode">
3) Perform the Inspection Mode. Inspection Mode">
4) Read the DTC. Read Diagnostic Trouble Code (DTC)">
Is the same DTC displayed?
Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0057 ECM COMMUNICATION CIRCUIT">Go to Step 5.
5.CHECK DETECTION OF OTHER DTCS FOR VDC.
Read Diagnostic Trouble Code (DTC)">
Is any other DTC displayed?
Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">
Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.
Installation
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementINSTALLATIONInstall in the reverse order of removal.CAUTION:Be sure to use SUBARU genuine air cleaner element depending on the engine type when replacing the air cleaner elements. Using other air cleaner element may affect the engine performance.NOTE: ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Cleaner ElementREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the air intake duct. Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B). ...
System block diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAM• Blind Spot Detection/Rear Cross Traffic Alert system consists of the following.• There is a control ECM in the radar sensor main body, which performs the vehicle identification ...