Subaru Crosstrek Service Manual: Dtc c0044 tcm communication circuit

DTC detecting condition:

No CAN signal from TCM.

Trouble symptom:

• ABS does not operate.

• VDC does not operate.

• EyeSight does not operate.

1.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault in LAN system?

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 2.

2.CHECK POOR CONTACT OF CONNECTORS.

Is there poor contact of TCM connector?

Repair the connector.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 3.

3.CHECK TCM.

Refer to the basic diagnostic procedure for Transmission (diagnostics).

Is the check result OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 4.

Replace the TCM. Transmission Control Module (TCM)">

4.CHECK VDCCM&H/U.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Perform the Inspection Mode. Inspection Mode">

3) Read the DTC. Read Diagnostic Trouble Code (DTC)">

Is the same DTC displayed?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0044 TCM COMMUNICATION CIRCUIT">Go to Step 5.

5.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)">

Is any other DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Currently, it is normal. There may have been a temporary poor contact in the harness and connector or a temporary noise interference.

Dtc c0042 power supply voltage failure

Dtc c0047 can communication

Other materials:

Procedure
LAN SYSTEM (DIAGNOSTICS) > CAN Communication Circuit CheckPROCEDURENOTE:• When measuring the resistance of CAN communication circuit, measure it in sleep status.To enter sleep status– With ignition switch OFF and key or switch operation stopped, keep the doors, trunk, and rear gate all c ...

Dtc p0711 transmission fluid temperature sensor "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0711 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:&b ...

General description
DIFFERENTIALS > Rear Differential Inspection ModeGENERAL DESCRIPTIONCAUTION:Be sure to perform rear differential inspection mode.• Follow the messages displayed on the Subaru Select Monitor when working.• “Rear differential inspection mode” using the Subaru Select Monitor ...