Subaru Crosstrek Service Manual: Dtc c0041 parameter selection error

DTC DETECTING CONDITION:

VDCCM parameter selection error

TROUBLE SYMPTOM:

• ABS does not operate.

• EBD does not operate.

• VDC does not operate.

• EyeSight does not operate.

When the VDCCM&H/U is replaced, this DTC may be stored.

1.CHECK VDCCM&H/U IDENTIFICATION SYMBOL.

Check the identification symbol attached on the H/U. General Description > SPECIFICATION">

Is the identification symbol correct?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C0041 PARAMETER SELECTION ERROR">Go to Step 2.

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

2.CHECK PARAMETER SELECTED IN VDCCM.

Subaru Select Monitor > OPERATION">

Does the parameter registered in the VDCCM match the relevant vehicle?

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

Select and register the correct parameter. Subaru Select Monitor > OPERATION">

Dtc c0041 ecm

Dtc c0042 power supply voltage failure

Other materials:

Removal
CLUTCH SYSTEM > Clutch SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. Disconnect the ground cabl ...

Installation
ENTERTAINMENT > GPS AntennaINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer to “CAUTION” ...

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Air Breather HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake ...