Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2a10 battery voltage high

TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2A10 BATTERY VOLTAGE HIGH

Diagnosis start condition:

When ignition switch is ON.

DTC detecting condition:

DCM battery power supply input of 16 V or more continues for 5 seconds.

Trouble symptom:

RED LED illuminates.

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A10 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A10 BATTERY VOLTAGE HIGH">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK CURRENT DATA.

Check «Battery Voltage» of «Data Monitor». Read Current Data">

Is «Battery Voltage» OK?

Replace the DCM. Data Communication Module">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A10 BATTERY VOLTAGE HIGH">Go to Step 3.

3.CHECK BATTERY.

Check the battery unit. Battery > INSPECTION">

Is the battery OK?

Replace the DCM. Data Communication Module">

Replace the battery. Battery">

Dtc b2a07 backup battery charge system performance
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCEDIAGNOSIS START CONDITION:When ignition switch is ON.DTC D ...

Dtc u0155 lost communication with instrument panel cluster (ipc) control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDetected when CAN data from c ...

Other materials:

Dtc u1120 lost communication with autostart stop control module
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULEDetected when CAN data from hybrid system or Auto Start Stop CM is abnormal.NOTE:Perform the diagnosis for LAN system. ...

Continuously variable transmission
WARNING Do not shift from the "P" or "N" position into the "D" or "R" position while depressing the accelerator pedal. This may cause the vehicle to jump forward or backward. CAUTION Observe the following precautions. Failure to observe these precautions could cause damage to the transmi ...

Component
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General DescriptionCOMPONENT1. TRANSMISSION CASE(1)Transmission case ASSY(7)Pitching stopper bracketTightening torque: N·m (kgf-m, ft-lb)(2)Gasket(8)Oil level gaugeT:44 (4.5, 32.5) (aluminum gasket, silver)(3)Drain plug(9)Harness clip 70 (7.1, 51 ...

© 2016-2024 Copyright www.sucross.com