Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2a05 left speaker/audio circuit

TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT

Diagnosis start condition:

When ACC is ON.

DTC detecting condition:

Speaker impedance is more than 10 k? for 100 ms. (Detached speaker connection, etc.)

Trouble symptom:

Call function cannot be used.

RED LED illuminates.

Wiring diagram:

NOTE:

For the coupling connector, refer to “WIRING SYSTEM”.

Telematics Telematics System > WIRING DIAGRAM">

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A05 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.PERFORM THE SYSTEM OPERATION CHECK.

Perform [Speaker ON] in the system operation check mode. System Operation Check Mode">

Does it sound?

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT">Go to Step 3.

3.CHECK HARNESS (OPEN CIRCUIT).

1) Turn the ignition switch to OFF.

2) Disconnect the speaker connector and tweeter connector.

3) Disconnect the DCM connector.

4) Measure the resistance between speaker connector and tweeter connector and DCM connector.

Connector & terminal

(i271) No. 2 — (D2) No. 2:
(i271) No. 2 — (i158) No. 1:
(i271) No. 10 — (D2) No. 1:
(i271) No. 10 — (i158) No. 3:

Is the resistance 1 ? or less?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT">Go to Step 4.

Repair or replace the open circuit of harness.

4.CHECK HARNESS (GROUND SHORT CIRCUIT).

Measure the resistance between DCM connector and chassis ground.

Connector & terminal

(i271) No. 2 — Chassis ground:
(i271) No. 10 — Chassis ground:

Is the resistance 1 M? or more?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT">Go to Step 5.

Repair or replace the short circuit of the harness.

5.CHECK THE CONNECTOR (SHORT CIRCUIT TO POWER SUPPLY).

Measure the voltage between DCM connector and chassis ground.

Connector & terminal

(i271) No. 2 (+) — Chassis ground (−):
(i271) No. 10 (+) — Chassis ground (−):

Is the voltage less than 1 V?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A05 LEFT SPEAKER/AUDIO CIRCUIT">Go to Step 6.

Repair or replace the short circuit of the harness.

6.CHECK THE SPEAKER.

Perform the inspection of speaker unit and tweeter unit. Front Speaker"> Rear Speaker">

Are the speaker and tweeter OK?

Replace the DCM. Data Communication Module">

Replace the speaker and tweeter. Front Speaker"> Rear Speaker">

Dtc b2a04 mic circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A04 MIC CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:Any of the followings ...

Dtc b2a06 right speaker/audio circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A06 RIGHT SPEAKER/AUDIO CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:Speake ...

Other materials:

Towing with all wheels on the ground
1. Release the parking brake and put the transmission in the "N" position. 2. The ignition switch should be in the "ON" position while the vehicle is being towed. 3. Take up slack in the towline slowly to prevent damage to the vehicle. WARNING Never turn the ignition switch to t ...

Vehicle finder function
Use this function to find your vehicle parked among many vehicles in a large parking lot. Provided you are within 30 feet (10 meters) of the vehicle, pressing the lock/arm button three times in a 5-second period will cause your vehicle's horn to sound once and its hazard warning flashers to fl ...

Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyASSEMBLY1. Install the reverse brake piston.NOTE:Apply CVTF to the sealing area of reverse brake piston.2. Install the return spring.3. Install the spring retainer.4. Compress the return spring using the ST to install the snap ring ...

© 2016-2024 Copyright www.sucross.com