Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2a03 gps antenna circuit

TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2A03 GPS ANTENNA CIRCUIT

Diagnosis start condition:

When ignition switch is ON.

DTC detecting condition:

Any of the followings continues for 5 seconds or more.

GPS antenna impedance is more than 1 M?. (Detached antenna, etc.)

GPS antenna impedance is less than 10 ?. (Short-circuited antenna, etc.)

Trouble symptom:

Telematics function cannot be used.

RED LED illuminates.

CAUTION:

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

STEPCHECKYESNO

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A03 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A03 GPS ANTENNA CIRCUIT">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK GPS ANTENNA.

Visually check the GPS antenna. GPS Antenna">

Is the GPS antenna OK?

Replace the DCM. Data Communication Module">

Replace the GPS antenna. GPS Antenna">

Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignit ...

Dtc b2a04 mic circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A04 MIC CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:Any of the followings ...

Other materials:

Preparation tool
SECURITY AND LOCKS > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to &ldqu ...

Removal
BRAKE > Master CylinderREMOVALCAUTION:• Do not allow brake fluid to come in contact with the painted surface of the vehicle body. If it does, wash off with water and wipe away completely.• Prepare a container to catch grease or oil, etc. If any grease or oil spills, wipe it off and cl ...

Engine noise Inspection
MECHANICAL(H4DO) > Engine NoiseINSPECTIONType of soundConditionPossible causeRegular clicking soundSound increases as engine speed increases.• Valve mechanism is defective• Incorrect cam clearance• Worn camshaft• Broken valve spring• Defective valve shimHeavy and dul ...

© 2016-2024 Copyright www.sucross.com