Subaru Crosstrek Service Manual: Dtc b2a01 tel1 antenna circuit

Diagnosis start condition:

When ignition switch is ON.

DTC detecting condition:

Any of the followings continues for 5 seconds or more.

• TEL1 impedance is more than 1 M?. (Detached antenna, etc.)

• TEL1 impedance is less than 1 k?. (Short-circuited antenna, etc.)

• Telematics function cannot be used.

• RED LED illuminates.

For the coupling connector, refer to “WIRING SYSTEM”.

CommCheck is required after replacing the DCM. Telematics System > OPERATION">

1.CHECK DTC.

Read the DTC. Diagnostic Code(s) Display">

Is DTC B2A01 displayed? (Current malfunction)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A01 TEL1 ANTENNA CIRCUIT">Go to Step 2.

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

2.CHECK HARNESS (OPEN CIRCUIT).

1) Turn the ignition switch to OFF.

2) Disconnect the antenna connector.

3) Disconnect the DCM connector.

4) Disconnect the PRG DU connector.

5) Measure the resistance between antenna connector and DCM connector.

Connector & terminal

(AN19) No. 1 — (AN24) No. 1:

Is the resistance less than 1 ??

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A01 TEL1 ANTENNA CIRCUIT">Go to Step 3.

Repair or replace the open circuit of harness.

3.CHECK HARNESS (GROUND SHORT CIRCUIT).

Measure the resistance between DCM connector and chassis ground.

Connector & terminal

(AN19) No. 1 — Chassis ground:

Is the resistance 1 M? or more?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A01 TEL1 ANTENNA CIRCUIT">Go to Step 4.

Repair or replace the short circuit of the harness.

4.CHECK HARNESS (SHORT CIRCUIT TO POWER SUPPLY).

1) Turn the ignition switch to ON.

2) Measure the voltage between DCM connector and chassis ground.

Connector & terminal

(AN19) No. 1 (+) — Chassis ground (−):

Is the voltage less than 1 V?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2A01 TEL1 ANTENNA CIRCUIT">Go to Step 5.

Repair or replace the short circuit of the harness.

5.CHECK ANTENNA.

Check the telematics antenna. Antenna">

Is the telematics antenna OK?

Replace the DCM. Data Communication Module">

Replace the telematics antenna. Antenna">

Diagnostic procedure with diagnostic trouble code (dtc)

Dtc u0452 invalid data received from restraints control module

Other materials:

Adjustment
LIGHTING SYSTEM > Headlight AssemblyADJUSTMENT1. HEADLIGHT BEAM ADJUSTMENTCAUTION:• Turn off the light before adjusting the beam level of the light assembly - head. If it is necessary to inspect the beam level, do not keep the light on for two minutes or more.• When blocking the light ...

Dtc c1252 wheel speed sensor signal of one of the wheels
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1252 WHEEL SPEED SENSOR SIGNAL OF ONE OF THE WHEELSDTC detecting condition:• Defective ABS wheel speed sensor signal (noise, irregular signal, etc.)• Defective magnetic encoder&b ...

List of diagnostic trouble code (dtc) List
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContents of diagnosisRemarksC2021TIRE 1 AIR PRESSURE LOW (NORMAL MODE)Tire pressure of tire 1 is reduced. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2021 TIRE 1 AIR PRESSURE LOW ...