Subaru Crosstrek Service Manual: Dtc b28b8 eyesight steering switch 1

Detected when EyeSight steering switch is not installed or has malfunction, or when the harness is faulty or open-circuited or in stuck ON condition.

DTC detecting condition:

• Wiring of the EyeSight steering switch is not connected.

• EyeSight steering switch circuit is open.

• EyeSight steering switch circuit stays ON.

1.CHECK CURRENT DATA.

Confirm the current data «Cruise Control SW Voltage (Port14)» and «Cruise Control SW Voltage (Port16)» of EyeSight using Subaru Select Monitor. Read Current Data">

Does the display change according to the EyeSight steering switch operation?

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, or temporary open or short circuit of harness may be the cause.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28B8 EyeSight STEERING SWITCH 1">Go to Step 2.

2.CHECK HARNESS.

1) Disconnect the stereo camera connector and EyeSight steering switch connector.

2) Using the tester, measure the resistance between stereo camera connector and EyeSight steering switch connector.

Connector & terminal

(ST3) No. 4 — (R137) No. 16:

(ST3) No. 3 — (R137) No. 14:

(ST3) No. 9 — (R137) No. 15:

Is the resistance less than 1 ??

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28B8 EyeSight STEERING SWITCH 1">Go to Step 3.

Repair or replace an open circuit in harness between the stereo camera connector and the EyeSight steering switch connector.

3.CHECK HARNESS.

Using the tester, measure the resistance between EyeSight steering switch connector and chassis ground.

Connector & terminal

(ST3) No. 4 — Chassis ground:

(ST3) No. 3 — Chassis ground:

(ST3) No. 9 — Chassis ground:

Is the resistance 1 M? or more?

Check the EyeSight steering switch. Switches and Harness">

Repair or replace the short circuit to ground in harness between the stereo camera connector and the EyeSight steering switch connector.

Dtc b28b7 ldp off switch

Dtc b28b9 eyesight steering switch 2

Other materials:

Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the air flow control dial or switch to check that the link operates normally.3. If it does not operate normally ...

Dtc b28a1 eyesight communication(ecm)
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28A1 EyeSight COMMUNICATION(ECM)Detected when the engine control module (ECM) detects the malfunction of stereo camera, or when the stereo camera or ECM is assembled incorrectly.DTC DETECTING CONDITION:• De ...

Rear seats
WARNING Seatbelts provide maximum restraint when the occupant sits well back and upright in the seat. Do not put cushions or any other materials between occupants and seatbacks or seat cushions. If you do so, the risk of sliding under the lap belt and of the lap belt sliding up over the ...