Subaru Crosstrek Service Manual: Dtc b28a5 engine torque limiter control prohibit

Detected when abnormal data is transmitted from stereo camera to engine control module (ECM) and the engine control module (ECM) prohibits the AT rapid start prevention control, or when the engine control module (ECM) prohibits the AT rapid start prevention control.

DTC DETECTING CONDITION:

• Defective CAN system

• Defective engine control module (ECM)

• Defective stereo camera

• Defective combination meter

• Incorrect assembly of combination meter (when the combination meter that is not for EyeSight is installed.)

• All functions of EyeSight system do not operate.

• EyeSight warning light illuminates.

1.CHECK COMBINATION METER.

Check the part number of the combination meter.

Is the combination meter genuine?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBIT">Go to Step 2.

Replace the combination meter. Combination Meter">

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is DTC displayed?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBIT">Go to Step 3.

3.CHECK ECM.

Perform the diagnosis for the engine. Basic Diagnostic Procedure > PROCEDURE">

Is DTC displayed?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBIT">Go to Step 4.

4.CHECK CONNECTOR.

Check the ECM connector and the stereo camera connector.

Is the connector OK?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBIT">Go to Step 5.

Repair or replace the connector.

5.CHECK STEREO CAMERA.

Read the DTC. Diagnostic Code(s) Display">

Is another DTC displayed?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B28A5 ENGINE TORQUE LIMITER CONTROL PROHIBIT">Go to Step 6.

6.CHECK STEREO CAMERA.

1) Clear the memory. Clear Memory Mode">

2) Read the DTC. Diagnostic Code(s) Display">

Is the same DTC displayed?

Replace the stereo camera. Stereo Camera > REMOVAL">

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, or temporary open or short circuit of harness may be the cause.

Dtc b28a3 eyesight communication(meter)

Dtc b28a6 internal stereo camera communication 1

Other materials:

Selection of manual mode
With the vehicle either moving or stationary, move the select lever from the "D" position to the "M" position to select the manual mode. Type A Upshift indicator Downshift indicator Gear position indicator Type B Upshift indicator Downshift indicator Gear position indi ...

Removal
LIGHTING SYSTEM > Rear Height SensorREMOVALCAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and remove the left rear wheel.3. Remove the sensor ...

Inspection
TELEMATICS SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with DCM is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Defective DCM• Defective CAN communica ...