KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B2790 ID CODE BOX CIRCUIT
DTC detecting condition:
An error has occurred inside the ID code box.
Trouble symptom:
Engine will not start.
CAUTION:
For replacement procedure of ID code box, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
STEP | CHECK | YES | NO |
1.CHECK DTC.
1) Turn the ignition switch to OFF.
2) Using the Subaru Select Monitor, clear the memory of «Keyless Access with Push Button Start». Clear Memory Mode">
3) Turn the ignition switch to OFF > ON.
4) Register the ID code box. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
5) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is DTC B2790 displayed?
Replace the ID code box. ID Code Box">
ID code box registration was not performed properly.
Accessory power outlets
Power outlet below the climate control dials
Power outlet in the center console
Accessory power outlets are provided
below the climate control dials and in the
center console. Electrical power (12V DC)
from the battery is available at any of the
outlets when the ignition switch is in e ...
Dtc c2323 transmitter 3 function code abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2323 TRANSMITTER 3 FUNCTION CODE ABNORMALNOTE:Refer to DTC C2324 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2324 TRANSMITTER 4 FUNCTION COD ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil Pump ChainINSTALLATION1. Clean the mating surface of oil pump chain cover and converter case.2. Using the ST, install the oil seal.NOTE:• Use a new oil seal.• Apply CVTF to the oil seal lip and press-fitting surface.ST 499755602PRESS ...