Subaru Crosstrek Service Manual: Dtc b278d id code box judgment circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B278D ID CODE BOX JUDGMENT CIRCUIT
DTC detecting condition:
• When ID code box setting is set to OFF, ID code box ON input is detected.
• When ID code box setting is set to OFF, ID code box LIN signal is received.
Trouble symptom:
Engine will not start.
CAUTION:
For replacement procedure of keyless access CM, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Wiring diagram:
Push button start system Push Button Start System > WIRING DIAGRAM">
| STEP | CHECK | YES | NO |
1.CHECK DTC.
1) Turn the ignition switch to OFF.
2) Using the Subaru Select Monitor, clear the memory of «Keyless Access with Push Button Start». Clear Memory Mode">
3) Turn the ignition switch to OFF > ON.
4) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
Is DTC B278D displayed?
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B278D ID CODE BOX JUDGMENT CIRCUIT">Go to Step 2.
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK HARNESS.
1) Disconnect the keyless access CM connector.
2) Measure the resistance between keyless access CM connector and chassis ground.
Connector & terminal
(B573) No. 15 — Chassis ground:
Is the resistance 10 k? or more?
Replace the keyless access CM. Keyless Access CM">
Repair or replace the short circuit of the harness.
Dtc b278a push engine switch power supply circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B278A PUSH ENGINE SWITCH POWER SUPPLY CIRCUITDTC detecting condition:When the ...
Dtc b27a1 driver side external antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A1 DRIVER SIDE EXTERNAL ANTENNA OPENDTC detecting condition:When open circ ...
Other materials:
Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Power Steering Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the power steering control module.(1) Disconnect the connector of the power steering control module.(2) Remove the nuts, and remove the power steering ...
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyDISASSEMBLY1. FORWARD CLUTCH ASSEMBLY1. Remove the snap ring.2. Remove the retaining plate, drive plate, driven plate and dish plate.3. Compress the return spring using the ST to remove the snap ring.ST1 18762AA010COMPRESSOR SP ...
Assembly
REAR SUSPENSION > Rear Lateral LinkASSEMBLY1. Before assembly, inspect the following items and replace any faulty part with a new one.• Visually check the lateral link assembly - rear for damage and deformation.• Visually check the bushing for abnormal cracks, fatigue or damage.2. Usi ...
