Subaru Crosstrek Service Manual: Dtc b2784 antenna circuit (push engine switch)

DTC detecting condition:

When open or short circuit occurs in the antenna coil.

Trouble symptom:

The keyless access function may not be operable.

CAUTION:

For replacement procedure of keyless access CM and steering lock CM, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

1.CHECK STEERING LOCK CM.

1) Disconnect the push button ignition switch connector.

2) Disconnect the keyless access CM connector.

3) Using the tester, measure the resistance between terminals.

Connector & terminal

(i150) No. 14 — (B574) No. 1:
(i150) No. 9 — (B574) No. 9:
(i150) No. 10 — (B574) No. 7:
(i150) No. 8 — (B574) No. 24:

Is the resistance less than 1 ??

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2784 ANTENNA CIRCUIT (PUSH ENGINE SWITCH)">Go to Step 2.

Repair or replace the open circuit of harness.

2.CHECK HARNESS.

Using the tester, measure the resistance between terminals.

Connector & terminal

(i150) No. 14 — Chassis ground:
(i150) No. 9 — Chassis ground:
(i150) No. 10 — Chassis ground:

Is the resistance 10 k? or more?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2784 ANTENNA CIRCUIT (PUSH ENGINE SWITCH)">Go to Step 3.

Repair or replace the short circuit of the harness.

3.CHECK PUSH BUTTON IGNITION SWITCH.

1) Replace the push button ignition switch. Push Button Ignition Switch">

2) Using the Subaru Select Monitor, clear the memory. Clear Memory Mode">

3) Read the DTC using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC B2784 displayed?

Replace the keyless access CM. Keyless Access CM">

Malfunction occurred in the push button ignition switch.

Dtc b2782 steering lock drive request signal correlation

Dtc b2785 lin communication

Other materials:

Dtc b1836 open in curtain airbag lh squib circuit
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1836 OPEN IN CURTAIN AIRBAG LH SQUIB CIRCUITDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (LH) circuit is open.• Curtain airbag module (LH) is faulty.&bul ...

Dtc u1120 lost communication with autostart stop control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULENOTE:The electric power steering CM identifies whether the Auto Start Stop function is provided or not using information from the combination meter. The ...

Check list for interview Check
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following items when a problem has occurred.NOTE:Use copies of this page for interviewing customers.Customer’s name Date of purchase Date of repair Transmission modelTransmissionV.I.N.Odometer readingk ...