Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b2327 rear radar internal failure (internal electric circuit)

Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B2327 REAR RADAR INTERNAL FAILURE (INTERNAL ELECTRIC CIRCUIT)

DTC DETECTING CONDITION:

Defective radar sensor

TROUBLE SYMPTOM:

All functions of BSD/RCTA stop.

Fail icon is displayed in the combination meter LCD display.

Failure-related notification is displayed for approx. two seconds on LCD display in the combination meter.

NOTE:

Check and replace the side that displayed the DTC.

STEPCHECKYESNO

1.CHECK BSD/RCTA.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Read the DTC again. Read Diagnostic Trouble Code (DTC)">

Is DTC B2327 displayed? (Current malfunction)

Replace the radar sensor. Radar Sensor">

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2313 rear radar detect vdc
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2313 REAR RADAR DETECT VDCDTC DETECTING CONDITION:Vehicle dynamics control ...

Dtc b2329 rear radar axis alignment incomplete
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2329 REAR RADAR AXIS ALIGNMENT INCOMPLETEDTC DETECTING CONDITION:Axis adjus ...

Other materials:

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Manual Transmission AssemblyREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSTALLATION1. Install the thrust bearing to the converter case.NOTE:Face the temper color surface to the converter case side.2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• When installing the ...

Clearance light and illumination light system Wiring diagram
WIRING SYSTEM > Clearance Light and Illumination Light SystemWIRING DIAGRAM ...

© 2016-2022 Copyright www.sucross.com