Subaru Crosstrek Service Manual: Dtc b2313 rear radar detect vdc
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B2313 REAR RADAR DETECT VDC
DTC DETECTING CONDITION:
Vehicle dynamics control (VDC) fails.
TROUBLE SYMPTOM:
• All functions of BSD/RCTA stop.
• Fail icon is displayed in the combination meter LCD display.
• Failure-related notification is displayed for approx. two seconds on LCD display in the combination meter.
• VDC warning light illuminates in the combination meter.
NOTE:
Check and replace the side that displayed the DTC.
| STEP | CHECK | YES | NO |
1.CHECK VDC.
Check the VDC. Basic Diagnostic Procedure">
Is there any fault?
Perform the inspection according to the VDC diagnosis.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2313 REAR RADAR DETECT VDC">Go to Step 2.
2.CHECK BSD/RCTA.
1) Restore the vehicle to its original state.
2) Perform the Inspection Mode. Inspection Mode">
Is DTC B2313 displayed? (Current malfunction)
Replace the radar sensor. Radar Sensor">
Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
NOTE:
In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
Dtc b2311 rear radar detect tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2311 REAR RADAR DETECT TCMDTC DETECTING CONDITION:Automatic transmission fa ...
Dtc b2327 rear radar internal failure (internal electric circuit)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2327 REAR RADAR INTERNAL FAILURE (INTERNAL ELECTRIC CIRCUIT)DTC DETECTING C ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSTALLATION1. Install the thrust bearing to the converter case.NOTE:Face the temper color surface to the converter case side.2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• When installing the ...
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
The light may remain illuminated for
a short period of time after the engine
has been started, especially in cold
weather. This does not indicate ...
Removal
ENTERTAINMENT > Front Accessory Power Supply SocketREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.1. Disconnect the ground cable from battery and wait for at least 60 seconds be ...
